Panasonic TX-86PW100A - Manual (Page 9)

9
Remote Control Television Operation
BUTTON WHAT IT DOES
STANDBY
The remote control button is used to turn the television into Standby mode. When
the television is in Stand-By it is possible to turn it back on by pressing this remote
control Power Button, the Programme Number UP or DOWN Button (front panel or
remote control) or any of the direct Programme Number Buttons.
PICTURE
This button is used to select the picture menu. Please refer to page 14 for detailed
operating instructions.
SOUND
This button is used to select the sound menu. Please refer to page 16 for detailed
operating instructions.
SET UP
This button is used to select the set up menu. Please refer to page 22 for detailed
operating instructions.
STEREO / MONO
Pushing the button changes the mode from Stereo to Mono and back again.
Normally the television will detect whether the broadcast signal is Mono or Stereo
and will set the mode accordingly. If the Stereo signal is weak or if the receiving
conditions are not the best, it is recommended that the Mono mode be manually
selected.
BILINGUAL *
This system allows two languages to be transmitted for one broadcast. Switching
between the Main (I) and (I) selects the desired language.
* Note: Bilingual sound is not currently available in Australia or New Zealand.
100Hz / PROGRE
This button allows you to change the Picture refresh setting between AUTO, 100Hz
MODE and PROGRESSIVE. Please refer to SCAN MODE on page 15.
SURROUND
This button switches the SURROUND on and off.
ASPECT
This button is used to move through the different aspect options of AUTO, 4:3,
ZOOM, S-ZOOM, 16:9, 14:9 and JUST. Please refer to page 23.
MULTI PIP (TX-86PW100A & TX-76PW100A only)
Pressing this button will access the Picture in Picture options. If the 4:3 aspect ratio
is selected you can choose between normal, Picture And Picture and Picture Out Of
Picture. All other aspect ratio settings let you choose between normal, Picture And
Picture and Picture In Picture.
Notes:
The MULTI PIP picture can be another television channel or an AV input.
While the On Screen Display is shown the sub-picture can be changed using the 0 ~
9 and the “- / - -” buttons, as shown on page 12.
When the On Screen Display disappears the main picture can be changed using the
0 ~ 9 and the “- / - -” buttons, as shown on page 12.
MULTI PIP is not available on the TX-76PW50A.
Please refer to drawing on Page 7 for location of Remote Control Buttons.