Peripheral failure – PictureTel 4500 User Manual
Page 94
88
Peripheral Failure
These are the steps to take if you have problems with your peripheral equipment.
If you have these
symptoms...
Do this...
No video and/or no
camera motion from your
auxiliary camera
1. Press
PREVIEW
for the
AUX A or B
video source.
2. Make sure that the cable connections at the
back of the camera are correct and secure.
3. Make sure that the cable connections from the
camera to the back of the video board are
correct and secure.
4. If there is a
POWER LED
on the back of the
camera, make sure it is lit.
No video from the
document camera or from
the slide Þlm-to-video
camera
1. Make sure that the cable connections at the
back of the camera are correct and secure.
2. Make sure that the cable connections from the
camera to the back of the video board are
correct and secure.
No audio or video from
the VCR
1. Make sure that the VCR tape has both audio and
video on it.
2. Disconnect the VCR cables from the electronics
module, and plug them directly into the
monitor.