Piaggio 400ie - Manual (Page 22)

01_21
Remote control programming
Follow these steps to program the remote controls:
1. Insert the remote control key to be programmed in the steering lock key block.
2. Turn the key to «ON», press the button on the remote control, release the button,
turn the key back to «OFF» from the «ON» position, all within 4 seconds.
3 Wait 1 to 8 seconds.
4. Repeat steps 2 and 3 for 4 times without removing the key.
The control unit confirms the programming has been successfully executed by open-
ing the saddle.
WARNING
TO STORE THE OTHER REMOTE CONTROLS TO MEMORY, (MAXIMUM 8), YOU
NEED TO REPEAT THE WHOLE PROCEDURE AGAIN. FAILURE TO CARRY OUT
THESE OPERATIONS WITHIN THE INDICATED TIMES WILL RESULT IN THE
AUTOMATIC CANCELLATION OF THE PROCESS FOR PROGRAMMING THE
REMOTE-CONTROLLED KEYS.
WARNING
AVOID PRESSING THE REMOTE CONTROL BUTTON MORE THAN ONCE WHEN
FAR AWAY FROM THE SCOOTER. THE SYNCHRONISM BETWEEN THE RE-
MOTE CONTROL AND THE RECEIVER CAN BE IMPAIRED. SHOULD THIS BE
THE CASE, REPEAT THE PROGRAMMING PROCEDURE. DO NOT KEEP THE
REMOTE CONTROL IN PLACES WITH TEMPERATURES EXCEEDING 60° C THE
BATTERY WILL RUN DOWN TOO QUICKLY.
22
1 Vehicle