Front suspension locking system, 2 use – Piaggio 400ie User Manual

Page 39

Advertising
background image

CAUTION

DO NOT ADJUST THE MIRRORS WHILE RIDING. THIS COULD CAUSE YOU TO
LOOSE CONTROL OF THE VEHICLE.

CAUTION

ANY CHANGES TO THE VEHICLE PERFORMANCE AS WELL AS ALTERATIONS
TO ORIGINAL STRUCTURAL PARTS IS STRICTLY FORBIDDEN BY LAW, AND
RENDERS THE VEHICLE NO LONGER CONFORMING TO THE APPROVED TYPE
AND DANGEROUS FOR RIDING.

02_11

Front suspension locking system (02_11, 02_12, 02_13, 02_14,
02_15, 02_16, 02_17)

The front suspension locking system simply prevents vehicle tilting when the «T »
switch is pressed. The vehicle can be stopped without your feet touching the ground.

The warning light «E» starts flashing when the key switch is set to «ON». This means
that the system is enabled for locking activation.

When the «T» switch is turned to «1 » a continuous sound alarm signals that the
locking system is engaged and, at the same time, the warning light «E» turns on
steadily.

When the «T switch is turned to «2» an intermittent sound alarm signals that the lock-
ing system is disengaged and, at the same time, the warning light «E » starts flashing
again. Warning light «E » turns off when riding starts. This means that the system
allows for vehicle tilting.

Engaging tilt locking is possible only if the following conditions occur at the same time:

Throttle completely untwisted

Engine rpm below 2500rpm

Vehicle speed below 10 km/h

39

2 Use

Advertising