Spark plug dismantlement – Piaggio 400ie User Manual

Page 51

Advertising
background image

TYRE INFLATION PRESSURE

Front tyre pressure (with
passenger)

1.6 bar (1.8 bar)

Rear tyre pressure (with
passenger)

2.4 bar (2.6 bar)

03_09

03_10

Spark plug dismantlement (03_09, 03_10)

Remove the port on the left-hand side panel of the vehicle by undoing the fixing screw
«A» and using a small screwdriver in the rear notch shown in the figure, then proceed
as follows:

1. Disconnect spark plug HV wire cap «B» ;

2. Unscrew the spark plug using the wrench supplied. ;

3. When refitting, place the spark plug in the hole at the due inclination and tighten it
by hand until it is finger tight;

4. Only use the wrench to lock it in place;

5. Place cap «B» fully over the spark plug.

6. Refit the port making sure the rear hook is inserted.

WARNING

THE SPARK PLUG MUST BE REMOVED WHEN THE ENGINE IS COLD. RE-
PLACE THE SPARK PLUG AS INDICATED IN THE SCHEDULED MAINTENANCE
TABLE. THE USE OF ELECTRONIC CENTRAL UNITS AND OF NON-COMPLIANT
ELECTRONIC IGNITIONS OR SPARK PLUGS OTHER THAN THOSE PRESCRI-
BED MAY SERIOUSLY DAMAGE THE ENGINE.

51

3 Maintenance

Advertising