Starting up the engine, 2 use – Piaggio 400ie User Manual

Page 33

Advertising
background image

02_06

02_07

02_08

Starting up the engine (02_06, 02_07, 02_08)

The vehicle is supplied with an ignition cut-off system, activated by the emergency
cut-off switch. The engine cannot be started if the ignition cut-off switch is in the OFF
position

A running engine automatically switches off when the ignition cut-off switch is set to
OFF.

The vehicle is equipped with automatic transmission with direct drive, so that starting
is effected by turning the throttle grip to idle speed; to start-off from still, progressively
twist the throttle grip. The vehicle is equipped with an electrical fuel pump that switches
on automatically as soon as the engine is started. The vehicle has a front suspension
locking system; a sensor placed under the saddle will prevent the vehicle riding, but
not its starting-up, if the rider is not seated in riding position.

To start-up the engine:

1. Rest the vehicle on its centre-stand, ensuring the rear wheel is not touching the
ground.

2. Maintain the throttle "C" completely untwisted.

3. Insert the key into the ignition switch «A» and turn it onto the ON position.

4. Make sure that the "I" switch is set onto the ON position.

5. Pull either the front, «D», or rear brake lever, «G», then press the starter button
«B».

WARNING

THE AUTOMATIC TRANSMISSION MAKES THE REAR WHEEL TURN EVEN
WHEN THE THROTTLE IS SLIGHTLY TWISTED. RELEASE THE BRAKE CARE-
FULLY AFTER STARTING, AND THEN ACCELERATE GRADUALLY.

33

2 Use

Advertising