Panasonic AJ-PD950 - Manual (Page 73)

Displaying the “HOURS METER” information
Turn the search dial to move the cursor (*). The description for the item where the cursor is located is shown on
the counter display.
Item No. Item Description
H00 OPERATION Displays the time that the power has been supplied in one-hour units.
H01 DRUM RUN Displays the time that the drum has been rotating in one-hour units.
H02 TAPE RUN Displays the time that the tape has been running during FF, REW, PLAY, SEARCH (JOG,
VAR, SHTL), REC, and EDIT modes (except for STILL in the JOG, VAR or SHTL mode) in
one-hour units.
H03 THREADING The number of times for threading/unthreading is displayed in single units.
H11 DRUM RUN r Displays the time that the drum has been rotating in one-hour units. (Can be reset)
H12 TAPE RUN r Displays the time that the tape has been running during FF, REW, PLAY, SEARCH (JOG,
VAR, SHTL), REC, and EDIT modes (except for STILL in the JOG, VAR or SHTL mode) in,
one-hour units. (Can be reset)
H13 THREADING r The number of times for threading/unthreading is displayed in single units. (Can be reset)
H30 POWER ON
The number of times the power has been turned on is displayed in single units.
<Notes>
.
The resettable items in the “HOURS METER” information are reset by the shop when performing maintenance or
other work.
.
The search buttons and the search dial cannot be operated while the DIAG menu is displayed.
If “T&S&M” is selected in the setup menu No. 008 (DISPLAY SEL), a message appears in the mode display
whenever a warning or error occurs. When multiple events occur, the event with the highest priority is displayed.
Priority Display
High Error messages
(See error message table)
INT SG
NO INPUT
Low
Warning messages
(See error message table)
Warning messages
Priority Monitor display
High FAN STOP
SERVO NOT LOCKED
LOW RF
HIGH ERROR RATE
Low
Description
When an abnormal operation is detected in this unit, the AUTO OFF lamp lights up
and an error message is displayed.
If “BB” or “CB” in No. 600 (INT SG) in the setup menu is selected, pressing the REC
button or the EDIT button (E to E mode) will display “INT SG” for the first two
seconds. This is also displayed for the first two seconds when starting editing.
If there is no input signal (except for analog audio) to the connector selected using
the INPUT SELECT switch, pressing the REC button or the EDIT button (E to E
mode) will display “NO INPUT” for the first two seconds. This is also displayed for
the first two seconds when starting editing.
When a warning occurs in this unit, the warning lamp lights up and a warning
message is displayed. When multiple warnings occur, the warning with the highest
priority is displayed.
Description VTR operation
This is displayed when the fan motor stops. Operation continues
This is displayed when the servo is not locked for three or
more seconds during playback, recording, or editing.
Operation continues
This is displayed when envelope levels approximately 1/3
that of normal levels are detected for more than one second Operation continues
during playback, recording, or editing.
This is displayed when the error rate increases and
correction/interpolation is performed on either the video or Operation continues
audio playback signal.
- 7 3 -