Panasonic AJ-PD950 - Manual (Page 86)

Specifications
Video Output Connector
Analog component output:
Analog composite output:
Serial digital component output:
SDTI output (option):
BNCx3 (Y, P B , P R ), 4:2:2/8:4:4*
Y: 1.0 Vp-p, 75
0.525/0.757 Vp-p switchable, 75 (75% color bar, 0% setup)
BNCx3, video 1, video 2, video 3 (superimpose on/off)
BNCx3, complies with SMPTE259M-C, 294M*standard, SDI 1, SDI 2, SDI 3,
(superimpose on/off)
BNCx1, complies with SMPTE305M standard
Video Signal Adjustment
Composite video input signal:
Video output gain:
Video output chroma gain:
Video output hue:
Video output setup:
Video output sync phase:
Video output SC phase:
±3 dB
±3 dB
±3 dB
±30°
±15 IRE
±8 s
±180°
AUDIO
Digital Audio
Sampling frequencies:
Quantizing:
Frequency response:
Dynamic range:
Distortion:
Crosstalk:
Wow & flutter:
Headroom:
48 kHz (synchronous with video)
16 bits
Emphasis:
20 Hz to 20 kHz ± 1.0 dB (at the reference level)
Better than 90 dB (1 kHz, emphasis OFF)
Less than 0.05% (1 kHz, emphasis OFF, reference level)
Less than -80 dB (1 kHz, between 2 channels)
Below measurable limit
525i/525p*: 20 dB
625i:
18dB
T1=50 s, T2 = 15 s (on/off selectable)
Cue Track
Frequency response:
300 Hz to 6 kHz ± 3 dB
Audio Input Connector
Analog input
(CH1/CH2/CH3/CH4):
Digital input
(CH1/CH2, CH3/CH4):
Serial digital input:
Cue track input:
Audio Output Connector
Analog output
(CH1/CH2/CH3/CH4):
Digital output
(CH1/CH2, CH3/CH4):
Serial digital output:
Cue track output:
Monitor output:
Headphones:
XLRx4, 600 /high impedance selectable, +4/0/-20 dBu selectable
XLRx2, AES/EBU format
Complies with SMPTE259M-272M (BNCx2, active through)
XLRx1, 600 /high impedance selectable, +4/0/-20/-60 dBu selectable
XLRx4, low impedance, +4/0/-20 dBu selectable
XLRx2, AES/EBU format
Complies with SMPTE259M-C/272M (BNCx1)
XLRx1, low impedance, +4/0/-20 dBu selectable
XLRx2, low impedance, +4/0/-20 dBu selectable
Variable level, mini-jack, 8
Other Input/Output Connectors
Time code input:
Time code output:
RS-422A input:
RS-422A output:
RS-232C:
Parallel input/output:
Encoder remote:
XLRx1, 0.5 to 8 Vp-p
XLRx1, 2.0 Vp-p
D-sub 9-pin, RS-422A interface
D-sub 9-pin, RS-422A interface
D-sub 25-pin, RS-232C interface
D-sub 25-pin
D-sub 15-pin
Weight and dimensions when shown are approximately.
Specifications are subject to change without notice.
*Applies only to AJ-PD950.
- 8 6 -