Panasonic AJ-PD950 - Manual (Page 49)

USER menu
<OPERATION>
Item
N o .
Superimposed
display
100 SEARCH
ENA
101 SHTL MAX
102 FF. REW
MAX
103 AUDIO
MUTE
1 0 4 R E F
ALARM
105 AUTO EE
SEL
106 EE MODE 0000 NORMAL This selects the EE mode output signals.
SEL 0001 THRU 0: Signals are output with a delay equivalent to the length of
107 PLAY
DELAY
Setting
N o .
Superimposed Description
0000
0001
0000
0001
0002
0000
0001
0002
0000
0001
0000
0001
0000
0001
0002
display
DIAL
KEY
This selects the direct search dial operation.
0: For direct search dial operations.
1: Operation is not transferred to the search mode unless the
0000
0015
x8
x16
x32
x16
x32
x50
OFF
ON
OFF
ON
S/F/R
STOP
BLACK
0
15
search button is pressed.
This sets the maximum speed for shuttle operations.
0: 8x normal speed
1: 16x normal speed
2: 32x normal speed
This sets the maximum speed for FF and REW operations.
0: 16 (32)x normal speed
1: 32 (60)x normal speed
2: 50 (100)x normal speed
<Note>
Values for the 411 (25M) mode are shown in parentheses (
).
This sets the status until the audio signal is output when
operation switches from the stop or search modes to the play
mode.
0: The time until the audio is output is shortened.
1: The audio is output after the status stabilizes.
<Note>
When set to 0 (OFF), the sound in the initially output part is
incomplete. Therefore, this setting is not recommended for
broadcasts.
This selects whether to warn the operator when the
REF.VIDEO signal has not been connected.
0: Warning is not given.
1: Warning is given by the flashing STOP lamp.
This selects the VTR mode in which the EE status is
established when the TAPE/EE switch is set to EE.
0: EE status is established in the STOP, FF or REW mode.
However, EE status is always established in EJECT mode
regardless of the TAPE/EE switch setting.
1: EE status is established only in the stop mode. However,
EE status is always established in EJECT mode regardless
of the TAPE/EE switch setting.
2: EE status is established only in the stop mode. However,
depending on TAPE/EE switch setting EJECT mode is as
follows:
TAPE/EE switch EE:
EE status
TAPE/EE switch TAPE: BLACK status for video
MUTE status for audio
internal signal processing.
1: Signals are output directly, without internal processing, and
so are output with no delay.
<Note>
When editing mode is selected, SDTI is selected as the video
input signal, or INT SG is selected at either VIDEO or AUDIO,
he internal operations are forcibly set to NORMAL.
This set the play delay time in frame increments.
The underline on the setting item denotes the initial setting.
- 4 9 -