Panasonic AJ-PD950 - Manual (Page 51)

USER menu
<INTERFACE>
Item
No. Superimposed
display
2 0 0 PARA RUN
201 9P SEL
2 0 2 ID SEL
2 0 3 25P SEL
204 RS232C SEL
2 0 5 BAUD RATE
2 0 6 DATA
LENGTH
2 0 7 STOP BIT
2 0 8 PARITY
2 0 9 RETURN
ACK
Setting
No. Superimposed
0000
0001
0000
0001
0000
0001
display
DIS
ENA
0000
0001
0000
0001
0000
0001
0002
0003
0004
0005
0000
0001
0000
0001
0000
0001
0002
0000
0001
OFF
ON
OTHER
DVCPRO
OFF
ON
OFF
ON
300
600
1200
2400
4800
9600
7
8
1
2
NON
ODD
EVEN
OFF
ON
Description
This selects whether two or more VTRs are to be operated in
synchronization.
0: No operation in synchronization
1: Operation in synchronization
<Note>
When operating two or more VTRs in synchronization, set
item 200 of all the VTRs to 0001.
This selects whether the 9P connector functions when the
REMOTE/LOCAL switch has been set to REMOTE.
0: Do not function
1: Function
This selects the ID information which is returned to the
controller.
0: 20 25H
1: DVCPRO ’s, own ID is returned (F0 33H).
This selects whether the PARALLEL (25P) connector functions
when the REMOTE/LOCAL switch has been set to REMOTE.
0: Does not function
1: Functions
These settings are for selecting whether the RS-232C
connector is to function when the REMOTE/LOCAL switch is
set to REMOTE.
0: Connector does not function.
1: Connector functions.
These settings are for selecting the RS-232C communication
speed (baud rate).
These settings are for selecting the RS-232C data length.
(Unit: bit)
These settings are for selecting the RS-232C stop bit length.
(Unit: bit)
These settings are for selecting the none, odd or even for the
RS-232C parity bit.
0: Parity bit is not used.
1: An odd number of bits is used for the parity system.
2: An even number of bits is used for the parity system.
These settings are for selecting whether the ACK code is to be
returned when a command is received from RS-232C.
0: ACK code is not returned.
1: ACK code is returned.
The underline on the setting item denotes the initial setting.
- 5 1 -