Operating range of the remote control unit, Preparation 05 – Pioneer PDP-508XDA User Manual

Page 19

Advertising
background image

Preparation

05

19

En

Operating range of the remote control unit

Operate the remote control unit while pointing it toward the remote
control sensor located at the bottom right of the front panel of the
plasma television. The distance from the remote control sensor
must be within 7 m and the angle relative to the sensor must be
within 30 degrees in the right, left, upward, or downward direction.

Note

• For the remote control sensor located on the PDP-428XDA, see

Part names on page 12.

Caution

• Do not expose the remote control unit to shock. In addition, do

not expose the remote control unit to liquids, and do not place
in an area with high humidity.

• Do not install or place the remote control unit under direct

sunlight. The heat may cause deformation of the unit.

• The remote control unit may not work properly if the remote

control sensor of the plasma television is under direct sunlight
or strong lighting. In such case, change the angle of the
lighting or plasma television, or operate the remote control unit
closer to the remote control sensor.

• When any obstacle exists between the remote control unit and

the remote control sensor, the remote control unit may not
function.

• As the batteries become empty, the remote control unit can

function within a shorter distance from the remote control
sensor. Replace the batteries with new ones early enough.

• The plasma television emits very weak infrared rays from its

screen. If you place such equipment operated through infrared
remote control as a VCR nearby, that equipment may not
receive commands from its remote control unit properly or
entirely. If this is the case, place that equipment at a location
far enough from the plasma television.

• Depending on the installation environment, infrared rays from

the plasma television may not allow this system to properly
receive commands from the remote control unit or may
shorten allowable distances between the remote control unit
and the remote control sensor. The strength of infrared rays
emitted from the screen differs, depending on images
displayed on the screen.

30º

30º

Remote
control
sensor

7 m

Advertising
This manual is related to the following products: