Pioneer PDP-508XDA - Manual (Page 37)

Setting up 08
37
En
Power Management (PC source only)
The system will be automatically placed into the standby mode
when no signal is received from the PC.
1 Press HOME MENU.
2 Select “Power Control” ( / then ENTER).
3 Select “Power Management” ( / then ENTER).
4 Select “Mode1” or “Mode2” ( / then ENTER).
5 Press HOME MENU to exit the menu.
Note
• This function is not selectable when the PC is connected to
the HDMI terminal.
Power Management
Selections Off (default) No power management
Mode1 • Places the system into the standby mode
when no signal is received from the
personal computer for eight minutes.
• Even when you start using the computer
and a signal is received again, the system
stays off.
• The system is switched on again by
pressing STANDBY/ON on the plasma
television or  on the remote control unit.
Mode2 • Places the system into the standby mode
when no signal is received from the
personal computer for eight seconds.
• When you start using the computer and a
signal is input again, the system is
switched on.
• The system is switched on again by
pressing STANDBY/ON on the plasma
television or  on the remote control unit.