PowerTec Regenerative Brushless DC Motor Control 1000AR - Manual (Page 32)

Model 1000AR Installation and Operation Manual P AGE
31
OFFICIAL 6/4/2001
I NSTALLATI O N CHECKLI ST
Is the Model 1000AR securely mounted in a vertical position (fuses up) [page 5]?
Is there a clear path for airflow through the base heatsink and through the chassis [page 5] ?
Is the temperature of the air surrounding the drive within specifications [page 5] ?
Is the AC power source for the drive of the proper voltage, frequency, and capacity [page 7] ?
Is the motor securely mounted and aligned [motor manual] ?
Is the drive and motor system properly grounded [pages 7 and 9] ?
Are the motor leads connected in the proper order [page 9] ?
Is the cable from the motor to the drive properly connected [page 9] ?
Is the bus loader installed and properly connected [page 11] ?
Are the regen resistors properly installed and connected [page 11] ?
If an Output or Dynamic Braking Contactor is used, is it properly interlocked [page13] ?
If Dynamic Braking is used, are the resistors properly installed and wired [page13] ?
Is the motor thermal properly wired to the drive [pages 14 and 15] ?
Is the Emergency Stop button properly installed [pages 14 and 15] ?
Are other drive controls properly wired [pages 14 and 15] ?
Is the Speed Reference source properly wired in [page 19 or 21] ?
Is the motor mechanically safe to run (an unloaded motor is recommended) ?
Is the machine safe to run and are all personnel clear ?
Proceed to the Start Up section.