About your projector, English – Panasonic PT VX400NTU User Manual

Page 20

Advertising
background image

About Your Projector

20

- ENGLISH

Preparation

(14) <POINTER> Button

Act as the On-Off switch for the Pointer.

(

Æ

page 37)

(15) <PAGE > Buttons

Scroll back and forth the pages on the screen

when giving a presentation. To use these buttons,

connect the projector and your computer with a

USB cable.

(16) <MUTE> Button

Mute the sound. (

Æ

page 38)

(17) <D.ZOOM +/-> Buttons
Zoom in and out the images. (

Æ

page 53)

(18) <FREEZE> Button
Pauses the projected image and sound

tentatively. (

Æ

page 39)

(19) <AV MUTE> Button

Temporarily turn off the image on the screen.

(

Æ

page 39)

(20) <SCREEN> Button

Select a screen mode. (

Æ

page 52)

(21) <P-TIMER> Button

Operate the P-timer function. (

Æ

page 39)

(22) <LAMP> Button

Select a lamp mode. (

Æ

page 39)

(23) ON/OFF switch

When using the remote control, set this switch to

“ON”. Set it to “OFF” for power saving when it is

not in use.

(24) Input Selection buttons: <COMPUTER

1>, <COMPUTER 2>, <HDMI>, <VIDEO>,

<S-VIDEO>, <NETWORK>.

These buttons are used to select the input signal.

(

Æ

page 38)

(25) <KEYSTONE> Button

Correct keystone distortion. (

Æ

page 37)

Attention

Do not drop the remote control.

z

Avoid contact with liquids.

z

Do not attempt to modify or disassemble the remote

z

control.

Note

The remote control can be used within a distance of

z

about 5 m (16.4 ft) if pointed directly at the remote control

signal receiver. The remote control can control at angles

of up to ± 30 ° vertically and ± 30 ° horizontally, but the

effective control range may be reduced.

If there are any obstacles between the remote control

z

and the remote control signal receiver, the remote control

may not operate correctly.

You can operate the projector by reflecting the remote

z

control signal on the screen. The operating range may

differ due to the loss of light caused by the properties of

the screen.

When the remote control signal receiver is lit with a

z

fluorescent light or other strong light source, the projector

may become inoperative. Set the projector as far from

the luminous source as possible.

(15)

(24)

(21)

(20)

(22)

(25)

(18)

(14)

(17)

(19)

(16)

(23)

Advertising