Panasonic PT VX400NTU - Manual (Page 31)

Powering ON/OFF
ENGLISH -
31
Basic Operation
Complete peripheral connections (with a 1 )
computer, VCR, etc.) before turning on the
projector.
Connect the projector’s AC power cord into an
2 )
AC outlet. The <POWER> indicator lights red.
Open the lens cap.
Press the <ON/STAND-BY> button on the control
3 )
panel or the <ON> button on the remote control.
The <POWER> indicator lights green and the
cooling fans start to operate. The preparation
display appears on the screen and the count
down starts.
After the countdown, the input source that was
4 )
selected the last time and the lamp power status
icon appear on the screen.
If there is no signal input when start on the
5 )
projector, or the current signal is missed while
operating the projector, the Video/Computer
selection window will be displayed on the screen,
please move the pointer to input source desired
by pressing the ▲▼ and the <SELECT> button.
And then follow the input signal guidance window
to correct the signal and connection.
If the projector is locked with a PIN code, PIN
code input dialog box will appear. Enter the PIN
code as instructed on the next page.
Note
When the [Logo select] function is set to [Off], the logo z
will not be shown on the screen ( Æ page 58).
When [Countdown off] or [Off] is selected in the [Display] z
function, the preparation display will not be shown on the
screen ( Æ page 57).
When the [Input search] function is set to [On 2], the z
input signal will be searched automatically ( Æ page 56).
When the [Direct on] function is set to [On], the projector z
will be turned on automatically by connecting the AC
power cord to an AC outlet.
Turning On the Projector
(2)
(3)
Video/Computer selection
06
Selected Input Source and Lamp power
Lamp power status
The preparation display will disappear
after 30 seconds .