Panasonic PT VX400NTU - Manual (Page 62)

Setting
62
- ENGLISH
Settings
PIN code change
J
The PIN code can be changed to your desired four-
digit number.
Press ▲▼ to select [PIN code change] 1 )
and then Press <SELECT> button.
[Current PIN code] dialog box appears. z
Press ▲▼ to enter the current code. 2 )
Press ► button to fix the number and
move the red frame pointer to the next
box.
The [New PIN code] input dialog box appears. z
Repeat these steps to set a new PIN 3 )
code.
Fan
Press ▲▼ to select [Fan] and then 1 )
Press <SELECT> button.
Press ▲▼ to select one option .
2 )
This function provides the following options in z
the cooling fans’ operation when the projector is
turned off.
L1 Normal operation.
L2
Slower and lower-sound than
the normal operation (L1), but
it takes more time to cool the
projector down.
Fan control
Press ▲▼ to select [Fan control] and 1 )
then Press <SELECT> button.
Press ▲▼ to select one among
2 )
options as below.
Choose the running speed of cooling fans from z
the following options according to the ground
elevation under which you use the projector.
Off Normal speed.* 1
On1 Faster than Off mode.* 2
On2 Faster than On 1 mode.* 3
Set this function to [Off] when using the projector *1 :
in non-high altitude environment.
Select this mode when using the projector in high *2 :
altitudes (about 1,200 meters or more above
the sea level) where the fans have less cooling
effect.
Select this mode when using the projector in *3 :
higher altitudes ( than above where the fans
have lesser cooling effect).
Note
Failure to set the running speed of cooling fans z
properly may affect the projector life.
The fan noise becomes louder in [On 1] and [On 2]. z
Video delay control
This function allows you to make a digital processing
of a projected image faster.
Press ▲▼ to select [Video delay 1 )
control] and then Press the <SELECT>
button.
Press ▲▼ to select one item between
2 )
On and Off.
Note
[Noise reduction] and [Progressive] can not be z
selected when [Video delay control] function is set
to [On].
Filter counter
This function is used to set a frequency for the filter
replacement.
Press ▲▼ to select [Filter counter]. 1 )
Press ►or the <SELECT> button to 2 )
access the submenu items.
Filter counter
J
Show the total accumulated time of the filter use timer
setting.
Timer
J
To set a timer. When the projector reaches the
selected time the "filter warning" icon appears on the
screen.
Press ▲▼ to select [Timer] and then 1 )
press the <SELECT> button.
Press ▲▼ to set the Timer.
2 )
Select from [Off/1000H/2000H/3000H/ z
4000H/5000H/6000H] depending on the use
environment.