Panasonic PT VX400NTU - Manual (Page 32)

Powering ON/OFF
32
- ENGLISH
Basic Operation
Enter a PIN code
PIN Code Input Dialog Box
When using the control panel
J
Press ▲▼ to enter a number. Press ► to fix the
number and move the red frame pointer to the next
box. The number changes to . If you fixed an
incorrect number, use the ◄ button to move the
pointer to the number you want to correct, and then
enter the correct number.
Repeat this step to complete entering a four-digit
number.
After entering the four-digit number, move the pointer
to “Set”. Press the <SELECT> button so that you can
start to operate the projector.
J
When using the remote control
Press the Number buttons on the remote control to
enter a number ( Æ page 19). When you complete
entering a four-digit number, the pointer moves to
“Set”. Press the <SELECT> button so that you can
start to operate the projector.
If you fix an incorrect number, use the ◄ button to
move the pointer to the number you want to correct,
and then enter the correct number.
If you entered an incorrect PIN code, PIN code and
the number () will turn red for a moment. Enter
the correct PIN code all over again.
Note
If the PIN code number is not entered or wrong PIN code z
number is entered within three minutes after the PIN
code dialog box appeared, the projector will be turned off
automatically.
The “1234” is set as the initial PIN code at the factory. z
After the “OK” icon disappears,
you can operate the projector.
While the projector is locked with the PIN code.
Put the label below (supplied) on in a prominent place
of the projector's body while it is locked with a PIN
code.
PIN code Protection