Pioneer XDJ-AERO - Manual (Page 24)

8 Turn the [MASTER LEVEL] control clockwise.
Sound is output from the speakers.
The [LEVEL] indicator lights.
Adjust the [MASTER LEVEL] control so that the orange indicator lights
where the track’s volume is highest (at the climax, etc.).
Be careful that the red indicator does not light, or the sound could be
distorted.
Mixing using the faders
Prepare the unit in advance so that the sound of [CH 1] is being output
from the speakers. For instructions on preparation, see Outputting
sound on page 23.
For instructions on monitoring the sound, see Monitoring sound with
headphones on page 20.
Mixing using the channel faders
1 Set [CROSS F. CURVE THRU, , ] (the crossfader
curve selection switch) to [THRU].
2 Switch the [DECK2, PHONO2/LINE2] selector switch in
the [CH 2] section.
3 Turn the [CH 2] [TRIM] control clockwise.
4 Press the [ (CH2)] button.
The sound of [CH 2] is monitored from the headphones.
5 Turn the [HEADPHONES MIXING] control.
This adjusts the balance of the monitor volume between the sound
output from the [MASTER OUT 1] and [MASTER OUT 2] terminals (the
sound of [CH 1]) and the sound of [CH 2].
6 Operate [DECK2].
While checking the sound over the headphones, adjust the tempo of
[CH 2] track to match the tempo of [CH 1] track.
7 While moving the [CH 2] channel fader to the back,
move the [CH 1] channel fader to the front.
While checking the sound output from the speakers, operate the chan-
nel faders to substitute the sound of [CH 1] with the sound of [CH 2].
Mixing is completed once only the [CH 2] sound is being output from the
speakers.
Mixing using the crossfader
1 Set [CROSS F. CURVE THRU, , ] (the crossfader
curve selector switch) to [ ] or [ ].
2 Operate [CH 2].
Operate as described in steps 2 to 6 under Mixing using the channel
faders on page 24.
3 Move the crossfader gradually to the right.
While checking the sound output from the speakers, operate the cross-
fader to substitute the sound of [CH 1] with the sound of [CH 2].
Mixing is completed once only the [CH 2] sound is being output from the
speakers.
Disconnecting links
Links with mobile devices can be disconnected.
! For instructions on disconnecting links with computers, see the
Operating Instructions for rekordbox (Mac/Windows).
1 Press the [INFO(UTILITY)] button for over 1 second.
The [UTILITY] screen is displayed.
2 Turn the rotary selector to select [LINK DISCONNECT],
then press the rotary selector.
A list of the mobile devices on which rekordbox (iOS/Android) is installed
and with which links with this unit are established is displayed on the
main unit display.
3 Turn the rotary selector to select the mobile device
whose link you want to disconnect, then press the rotary
selector.
The link with the selected mobile device is disconnected.
24 En