Pioneer XDJ-AERO - Manual (Page 28)

List of WLAN SETTING items
When [MODE] at [WLAN SETTING] is set to [OFF], only [MODE] and [RESET TO DEFAULT] are displayed.
Setting item 1 Setting item 2 Setting ranges Description
MODE —
OFF/ACCESS POINT(AP)*/
WLAN CLIENT
Used to set this unit’s operation mode.
INPUT WPS PINCODE 1 — 0 to 9 (max. 8 characters)
When in the access point mode, input the PIN code of the sub unit
to be connected to this unit here to authorize connection.
NETWORK SETTING 1
SSID
A to Z, a to z, 0 to 9, symbols
(max. 32 characters)
Used to set this unit’s [SSID].
SECURITY OPEN / WPA / WPA2 Used to set this unit’s security (encryption) type.
PASSWORD
A to Z, a to z, 0 to 9, symbols
(max. 64 characters)
Used to set this unit’s password.
OTHERS 1
IP ADDRESS Sets this unit’s IP address.
SUBNET MASK Sets this unit’s subnet mask.
CHANNEL NO. CH1～AUTO*
This unit uses the 2.4 GHz band. If there is a wireless LAN network
on the same band in the area and the waves cause interference,
making connections and communications instable, try changing
the channel manually. (By default, this is set to [AUTO] and a
relatively free channel is selected automatically.）
DHCP SERVER ENABLE*/DISABLE
Used to set whether or not to enable this unit’s DHCP server
function.
[ENABLE]: Enables the DHCP server function.
[DISABLE]: Disables the DHCP server function.
CHANNEL WIDTH 20 MHz*/40 MHz
Used to set the frequency band’s width.
Only set [40 MHz] when communications are possible by
IEEE802.11n. Otherwise leave this at [20 MHz].
KEY RENEWAL INTERVAL
0minute to 60minute* to
1440minute
When [WPA] or [WPA2] is set at [SECURITY] under [NETWORK
SETTING], the encryption key’s renewal interval can be set.
When this setting is made, the encryption key is renewed automati-
cally at specific intervals, maintaining a more secure status.
RESET TO DEFAULT — YES/NO* Resets the settings at [WLAN SETTING] to the factory defaults.
SELECT SSID
2 —
Method of selection + input
method Displays up to 10 receivable networks (SSIDs) in the area. “OTHER”
at the bottom is used to specify an [SSID] that is not displayed.
DHCP CLIENT
2 — ENABLE*/DISABLE
Used to select whether to acquire the network settings automati-
cally using the DHCP function on the connected network side or to
set them manually.
[ENABLE]: Acquire the IP address, subnet mask, etc., automatically.
[DISABLE]: Input the IP address, subnet mask, etc., manually.
IP ADDRESS/SUBNET MASK —
000:000:000:000 to
255:255:255:255
(Set to 192:168:1:1/255:255:255:0
upon purchase.)
When in the access point mode, the fixed values below are set.
IP address: 192.168.1.1
Subnet mask: 255.255.255.0
When [DHCP CLIENT] is set to [DISABLE], the values must be input
manually.
*: Setting upon purchase
1 Not displayed in the WLAN client mode.
2 Items marked “**” are not displayed in the access point (AP) mode.
28 En