Planar C3013T - Manual (Page 10)

Clean Screen Mounts and Accessories P/N
12" wall mounted swing arm M3S12
Flush wall mount system (for head and keyboard cabinet) M3WC0
Flush wall mount system (head only) M3FHM
Roll stand only M3POLE
Roll stand with batteries (not for use with the C3013T product) M3POLE-PS
Batteries CBATT
IS Manager’s Kit C3DOC
IS Manager’s Kit, TOUCH C3DOC-TS
Keyboard cabinet with keyboard and mouse M3W00
External floppy drive C3FLOP
Safety Instructions
Your Planar Clean Screen PC has been designed, assembled, and inspected to ensure both the
highest quality product and greatest level of safety for the user. To maintain both quality and
safety, you must follow the instructions in the manual and the following safety guidelines.
1. Read the safety and installation guidelines carefully.
2. Keep the manual handy for future reference.
3. Install and use the Clean Screen only on a sturdy surface and in stable surroundings.
4. Use the Clean Screen in dry environments only.
5. Do not block vents or other slots on the Clean Screen housing.
6. Use only the power supply module included with the Clean Screen.
7. Use and maintain the safety ground plug set (power cord) included with the unit.
8. After the Clean Screen has been installed, secure all electrical cords out of the way to prevent
the unit from being pulled off the table or other accidental damage.
9. Turn off and unplug the Clean Screen before removing the Clean Screen’s back housing to
access internal user serviceable parts.
10. Avoid placing the Clean Screen or any of its cables on or near heat sources.
11. Clean Screen and its power supply meet the UL2601 standard for cleaning in a hospital
environment. Please see Chapter Six: Care and Cleaning for details.
12. Before cleaning, or if the unit becomes wet for any reason, it is always best to disconnect
the unit from its power source.
13. Practice caution when moving the Clean Screen to a different location. Use original pack-
aging whenever possible.
14. If the Clean Screen does not power-up when the power is switched on, refer to the
Troubleshooting section of this manual in Appendix C and follow the directions. If the Clean
Screen still does not work, immediately disconnect it from its power source and contact a
qualified service technician.
If this device is used in a medical facility, any application software used on the
Clean Screen PC must be in the language of the user.
Installation Guide ix
CS Manual LAYOUT#1787 3/9/98 5:33 PM Page ix