Planar C3013T - Manual (Page 18)

Installing an ISA Adapter Card
Figure 9
Do not remove the T-Bar or standoffs.
1. Remove the back housing as above.
2. Remove the blank metal spacer from the ISA panel slot using the T10 torx driver.
3. Locate the ISA connection beneath the T-Bar.
4. Turn the 1 ⁄
2
-card size ISA board upside down as you orient it toward the connection and the
ISA panel slot.
5. Slide the card under the T-Bar, into the ISA connector and the ISA panel slot.
6. Tighten the torx screw on the ISA panel slot.
Chapter Three: Hardware Installation and Replacement 7
CS Manual LAYOUT#1787 3/9/98 5:33 PM Page 7