Planar C3013T - Manual (Page 40)

Restore Condition
This option determines under what conditions the System BIOS will restore CMOS RAM from
FBD main block #1 when booting. The restore conditions are: Always; Never; and Bad CMOS.
The default is Never. After replacing the CMOS battery you can replace the lost information by
setting this parameter to Always or Bad CMOS and then exiting and rebooting. The CMOS will
be updated during the reboot. You can then reset this parameter to Never.
Clear Over Temperature Error
Selecting this clears the system Over Temperature Error once <enter> is pressed. An Over
Temperature Error is created when the internal temperature exceeds 50˚C, preventing damage to
the flat panel display. Should this condition persist, see the Problems and Suggestions section in
Appendix C.
Chapter Five: BIOS Setup 29
CS Manual LAYOUT#1787 3/9/98 5:33 PM Page 29