Pioneer AVIC-D1 - Manual (Page 106)

104
Chapter 8
Customizing the Audio Source Setting
AV
Changing the Wide Screen
Mode
• For safety reasons, these functions are not
available while your vehicle is in motion.
To enable these functions, you must stop
in a safe place and put on the parking
brake before setting your route (see page
12 Interlock for details).
1
Touch “WIDE” to select the desired set-
ting.
Touch “WIDE” repeatedly to switch between
the following settings:
NORMAL (normal) — FULL (full) — JUST
(just) — CINEMA (cinema) — ZOOM (zoom)
NORMAL (normal):
A 4:3 picture is displayed as it is, giving you no
sense of disparity since its proportions are the
same as that of the normal picture.
FULL (full):
A 4:3 picture is enlarged in the horizontal
direction only, enabling you to enjoy a 4:3 TV
picture (normal picture) without any omis-
sions.
JUST (just):
The picture is enlarged slightly at the center
and the amount of enlargement increases
horizontally toward the ends of the picture,
enabling you to enjoy a 4:3 picture without
sensing any disparity even on a wide screen.
CINEMA (cinema):
A picture is enlarged by the same proportion
as FULL or ZOOM in the horizontal direction
and by an intermediate proportion between
FULL and ZOOM in the vertical direction;
ideal for a cinema-sized picture (wide screen
picture) where captions lie outside.
ZOOM (zoom):
A 4:3 picture is enlarged in the same propor-
tion both vertically and horizontally; ideal for a
cinema-sized picture (wide screen picture).
❒ Different settings can be memorized for
each video source.
❒ When video is viewed in a wide screen
mode that does not match its original
aspect ratio, it may appear differently.
❒ Remember that use of this system for
commercial or public viewing purposes
may constitute an infringement on the
author’s rights protected by the Copyright
Law.
❒ Video will appear grainy when viewed in
CINEMA or ZOOM mode.
❒ The navigation map and the rear view cam-
era picture is always FULL.
Operating the Picture Adjust-
ment
• For safety reasons, these functions are not
available while your vehicle is in motion.
To enable these functions, you must stop
in a safe place and put on the parking
brake before setting your route (see page
12 Interlock for details).
You can adjust BRIGHT (brightness),
CONTRAST (contrast), COLOR (color) and
HUE (hue) for each source and rear view cam-
era.
1
Press P.ADJ/B.LIGHT button to display
PICTURE ADJUST.
BRIGHTNESS — Adjust the black intensity
CONTRAST — Adjust the contrast
COLOR — Adjust the color saturation
HUE — Adjust the tone of color (red is
emphasized or green is emphasized)
DIMMER — Adjust the brightness of display
BACK-CAMERA — Switch to the picture
adjustment display for the rear view camera
Other Functions