Pelco ESPRIT ES30PC - Manual (Page 10)

10 C311M-N (6/06)
7. Install mount; refer to the installation manual supplied with the mount for instructions.
8. Turn on the power. If the red LED lights, turn off the power and proceed to the next step. If the red LED does not light, refer to the
Troubleshooting section.
9. Plug the male Esprit system connector, located on the bottom of the pan and tilt, into the female Esprit system connector located on the
transformer module. Align the pan and tilt part number with the alignment label of the base and then attach the pan and tilt to the base
with three 1/4-20 nuts and washers (supplied).
10. Set the receiver address and system baud rate by configuring DIP switches SW1 and SW2.
NOTE: If you have a Coaxitron controller, you do not have to set the DIP switches. The Esprit will sense and automatically select settings
from Coaxitron control signals in either standard or extended mode.
To set the DIP switches:
a. Remove the plug from the left cover of the pan and tilt. It is not necessary to remove the pan and tilt cover.
b. Set the baud rate (SW1) and receiver address (SW2). For switch settings refer to the labels located on top of the camera module or
Tables A and B in the “Appendix” on page 63.
AUX 2
AUX 2 COM
AUX 2
AUX 2 COM
D1
1N4005
K1
OMRON G5V-1-DC12
V1
32 VDC
ESPRIT
ORANGE WIRE
BLUE WIRE
AUX2 Schematic Drawing
USER
ACCESSORY
NOTE: CURRENT MUST NOT EXCEED 40 mA.
PART
NUMBER
MALE SYSTEM
CONNECTOR
ALIGNMENT
LABEL
FEMALE
SYSTEM
CONNECTOR