Pelco ESPRIT ES30PC - Manual (Page 12)

12 C311M-N (6/06)
TXB Series Translator Board Installation (Optional)
Pelco’s TXB Series allows controllers from other companies to communicate with the Esprit system.
To install a TXB Series board, remove the left cover of the pan and tilt. Once the cover is removed, refer to the manual supplied with the
translator board to complete the installation.
HOW TO REMOVE THE PAN AND TILT COVER
1. Unscrew the Phillips head screw located on the left cover of the pan and tilt.
2. Remove cover and place to the side.
HOW TO REINSTALL THE PAN AND TILT COVER
The pan and tilt covers must be properly seated and have a tight seal all the way around when installed.
To reinstall the pan and tilt cover, do the following:
1. Properly position the cover and slide it into place. The sides of the cover must fit under the front and back rain guards of the pan and tilt,
and the top of the cover must seat against the lip of the top gasket.
2. Apply pressure and push the top of the cover down to align the fastener holes.
3. Insert the Phillips head screw and tighten. Tighten until the screw will not turn.
PLUG
PHILLIPS
SCREW
NOT SEALED
THIS SIDE IS
IMPROPERLY
INSTALLED
GAP
THIS SIDE IS
PROPERLY
INSTALLED