Pelco ESPRIT ES30PC - Manual (Page 35)

C311M-N (6/06) 35
DIRECTION LINE
Direction Line controls the vertical display position of the Direction label. The label may be displayed on lines 3 through 10. Line 3 is the third line
from the top of the screen and line 10 is located at the bottom of the screen. Line 10 is the default setting.
NOTE: Direction display is not available while you are programming or running a pattern.
To program the vertical label position for direction:
1. Program preset 95 (28). The main menu appears.
2. Position the cursor (>) beside Other.
3. Press the Iris Open button to enter the Other menu.
4. Position the cursor (>) beside Az/El/Direction.
5. Press the Iris Open button to enter the Az/El/Direction menu.
6. Position the cursor (>) beside Direction Line.
7. Press the Iris Open button. The cursor moves to the right.
8. Move the joystick up or down to view the available selections.
9. SELECT: Press the Iris Open button to make a selection.
CANCEL: Press the Iris Close button to cancel selection.
Proportional pan On
Park time minutes 0
Scan Speed deg/s 25
Pattern Length 1.5 min
Spd Profile
<Zone Blank>
<Az/El/Direction>
Exit
Other Menu
<Camera>
<Line Sync>
<Power Up>
<Wiper>
<Limit Stop>
<Alert>
<Other>
ACK Alert
Exit
MAIN MENU Az/El/Direction
Set Azimuth Zero
Az/El
Az/El Line
Direction
Direction Line
Zoom
Zoom Line
Disp Duration
Exit