Pelco ESPRIT ES30PC - Manual (Page 54)

54 C311M-N (6/06)
WIPER MODE
There are three wiper settings:
• Wiper Mode (Momentary or Continuous)
• Wiper Dwell
• Wiper Time
To change the wiper settings:
1. Program preset 95 (28). The main menu appears.
2. Position the cursor (>) beside Wiper.
3. Press the Iris Open button to enter the Wiper menu.
4. Move the joystick up or down to position the cursor next to one of the wiper settings.
5. Press the Iris Open button. The cursor moves to the right.
6. Move the joystick up or down to toggle between through the choices.
7. SELECT: Press the Iris Open button on your keyboard to select your choice.
CANCEL: Press the Iris Close button if you do not want to change the setting.
To operate the wiper feature do the following:
• Momentary Mode: To operate the wiper one full cycle, press the AUX 1 button on your controller. Each press of the button operates the
wiper one full cycle, even if the AUX 1 button is latching. If AUX 1 is latching, the first press will activate the wiper (open the latch).
Pressing AUX 1 a second time closes the latch, but will not cycle the wiper. Press the AUX 1 key again to cycle the wiper.
• Continuous Mode: To operate the wiper press the AUX 1 button on your controller. The wiper will continue to operate until the AUX 1
button is pressed again or until the programmed cycle is completed.
NOTE: CM9740 and CM9760 Matrix Systems Only – For the wiper to operate in continuous mode, the AUX 1 function in the camera file must
be set to latching. If the AUX 1 camera file is not latching, the wiper will only operate in momentary mode, even if the Esprit wiper is
programmed for continuous operation. Refer to the operation manual supplied with the CM9740 or CM9760 matrix system for instructions.
• Wiper Dwell: The time between wiper cycles. The dwell time can be programmed from 2 to 30 seconds.
• Wiper Time: The length of the wiper cycle. Wiper time can be programmed from 60 to 1,440 minutes (1 to 24 hours).
Wiper Mode Momentary
Wiper Dwell <s> 2
Wiper Time <m> 60
Exit
Wiper Menu
<Camera>
<Line Sync>
<Power Up>
<Wiper>
<Limit Stop>
<Alert>
<Other>
ACK Alert
Exit
MAIN MENU