Phonetics Sensaphone ISACC 5000 - Manual (Page 72)

72
Sensaphone ® ISACC Instruction Manual
STAND ALONE COMMANDS
The STAND ALONE commands are used without the command prefix SET or SHOW to
execute an action. The STAND ALONE commands are:
RESET EXIT
CLEAR DATA
PATCH 123
HELP DIAG
The format for using a STAND ALONE command is the following:
ISACC>(COMMAND)
RESET
ISACC keeps track of all the highest and lowest events for each analog input. These are
labelled MIN and MAX values. The RESET command allows you to reset the MIN and
MAX values for all the analog inputs, or for one specific input.
If an input is defined as a pulse counting input, then the RESET command will clear the pulse
count to zero.
To reset all minimum and maximum values, type reset after an ISACC prompt. To reset a
specific input's minimum and maximum values, type reset followed by the input number.
ISACC>reset
Minimum/maximum and pulse count values reset
CLEAR
This command is used to stop a dialout in progress for all inputs, or for one specific input, by
clearing the alarms.
To clear all alarms, type clear after an ISACC prompt. To clear a specific alarm, type clear
followed by the input number.
ISACC>clear
CLEAR DIALOUT ALARMS
Input #01 cleared
Input #02 cleared
Input #03 cleared
Input #04 cleared
Input #05 cleared
Input #06 cleared
Input #07 cleared
Input #08 cleared
Input #09 cleared
Input #10 cleared
Input #11 cleared
Input #12 cleared
Input #13 cleared
Input #14 cleared
Input #15 cleared
Input #16 cleared