Panasonic RAMSA WR-DA7 - Manual (Page 11)

1 - 5
Setting up the DA7
Set up the DA7 for transmitting and receiving data with your PC.
1. Select the MIDI button in the SETUP section on the TopPanel of the DA7
to display the [MIDI>SETUP] Window of the LCD display. This is so you
can set up the transmit and receive data parameters.
2. Select [TO PC] in the [PORT SELECT] area in the [SERIAL I/O SETUP]
area.
3. Cursor to [BAUD RATE] within the [SERIAL I/O SETUP] area of the
[MIDI>SETUP] window. Use the parameter dial to select [38.4K].
4. Cursor to [PORT], and select [TO PC] in both the [Gen RX] and [Gen TX]
fields in [MIDI>SETUP] window.
5. Cursor to the [CH] area. Be sure to select the same MIDI CH numbers
that are used on the Upgrade Utility’s [SET UP] window in the [Gen RX]
and [Gen TX] fields. Remember that all MIDI channel #s must be the
same.
6. Cursor to the [SYSTEM EX] field. Select [TX] and press ENTER. Select
[RX] and press ENTER.
MIDI SETUP Window