Panasonic RAMSA WR-DA7 - Manual (Page 34)

2 - 8
10. New shortcut to return to the [CHANNEL] window from the [D-
I/O>TO SLOT] window.
Previous Versions: To return to the [CHANNEL] window from within the
[D-I/O>TO SLOT] window, you had to press the CHANNEL button in the
MASTER DISPLAY section.
Version 2.0: Now to return to the [CHANNEL] window from the [D-I/O>TO
SLOT] window, press the DIRECT key in the assignment section of the
centrally assignable channel strip on the Top Panel of the DA7.
11. Output assignments are now saved when using the DIRECT button.
Previous Versions: Assignments were cleared when using the DIRECT
button
Version 2.0: All previous assignments are now saved when the DIRECT
button is pressed for direct channel assignments to the CARD SLOTS.
12. The [AUTOMATION>EXECUTE] default window has changed.
Previous Versions: Arming the Automation via the AUTOMATION/AUX LED
button on the Top Panel puts Automation into Record, and retains the
currently selected LCD screen.
Version 2.0: Now when you press the AUTOMATION/AUX LED button on the
Top Panel of the DA7 to enable Automation for recording, the
[AUTOMATION>EXECUTE] window is displayed on the LCD.
13. New Automation default.
Previous Versions: When executing a NEW MIX in the
[AUTOMATION>SETUP] window, the DA7 did not change the FADER EDIT
MODE. The default was the DA7 would recall the last selection of the FADER
EDIT MODE, and it would be used for the NEW MIX.
Version 2.0: When NEW MIX is selected in the [AUTOMATION>SETUP]
window, the FADER EDIT MODE automatically defaults to ABSOLUTE.
14. New Cursor position default for the [AUTOMATION>EXECUTE]
window.
Previous Versions: The Factory default cursor position in the
[AUTOMATION>EXECUTE] window was within the HOURS box of the TIME
CODE OFFST.