Panasonic RAMSA WR-DA7 User Manual
Page 40
2 - 1 4
35. New default BUS assignments when creating a stereo BUS.
Previous Versions: When the BUS was set to stereo, the BUS assignments
from the monaural channel was copied to the other channel of the pair.
Version 2.0: This problem is solved.
36. Correction of the sub-code data in the digital output signal.
Previous Versions: The sub-code data was always AES/EBU for the REC OUT,
AUX1, 2 and the AES/EBU Card (WR-AESS). The DA7 would only send
AES/EBU sub-code data, even if S/PDIF was selected using the hardware
switches.
Version 2.0: The format of the sub-code data can now be selected from
AES/EBU and S/PDIF from within the DIGITAL OUTPUT SELECT Window in
the Digital I/O screen. However, the buttons for switching the sub-code
format in the screen do not change the hardware switches used for selecting
the electric specification on the rear panel or on the AES/EBU cards. These
selections must be made in addition to the settings in the DIGITAL OUTPUT
SELECT Window. Therefore, the output switch and the sub-code area for
must be in the same position.
[D-IO>INPUT SET] window