Parker Hannifin 192-510011N7 - Manual (Page 30)

Accessories for HLE and HLEZ
Automation
30 Parker Hannifin GmbH
Electromechanical Division
Highly flexible, thin lines with a low bending strength should be loosely gathered together and routed in order in a protective
hose. When selecting the size of the protective hose, ensure that its area is considerably greater than the sum of the individual
cross-sectional areas. As a guide, allow approximately 10 % of the diameter of each line as clearance.
Load diagrams
Maximum suspended length vs. additional load Maximum length with permitted deflection vs. additional load
1
0
2
3
4
5
0 1 2 3
0.625
0.450
0.320
0 2 4 6
suspended length
L
f
in m
stroke L
S
in m
additional load q
z
in kg/m
L
S
L
f
0.625
0.450
0.320
0 1 2 3
0 2 4 6
0
1
2
3
4
5
Length with
deflection L
D
in m
Stroke L
S
in m
additional load q
z
in kg/m
L
D
L
S
KR
KR 52 94 150
4
8
KR 200 300
Determining the chain length
Suspended chain Chain with permitted deflection
0.320: rounded to a multiple of 32 mm 0.320: rounded to a multiple of 32 mm
0.450: rounded to a multiple of 45 mm 0.450: rounded to a multiple of 45 mm
%
6
.
/
/
/ 

0.625: rounded to a multiple of 62.5 mm
%
6
.
/
.5 /
/ 


0.625: rounded to a multiple of 62.5 mm
Longitudinal flange connection set (option V)
Longitudinal flange plates make it possible to move more than the standard available stroke. A flange connection is always
necessary if the maximum travel path is exceeded (refer to Technical data, pages 6 and 20). Profile sections should normally
be split equally, with the separation point close to a fixing point. The bearing distance should generally be between 1.0m and
1.5m. If a longitudinal flange connection is used to extend the travel distance, the load data must be reduced as shown in the
table below. An HLE with a longitudinal flange connection should only be installed with the profile aperture in the top or the
bottom.
Unit HLE80 HLE100 HLE150 HLEZ100 HLEZ150
maximum permitted load N 0.5 x Fx *1 0.5 x Fx *1 0.5 x Fx *1
Speed m/s < 1 < 1 < 1
Acceleration m/s 2 < 1 < 1 < 1
Repeatability mm > ±0.5 > ±0.5 > ±0.5
unchanged
*1. Fx-HLE: refer to page 7;
A
A
Section A-A
FL
FB
HB FD
Model / size Type FL FB FD HB
HLE80 LVS80 300 70 15 80
HLE100 / HLEZ100 LVS100 400 90 15 100
HLE150 / HLEZ150 LVS150 500 130 15 150