Parker Hannifin 192-510011N7 - Manual (Page 7)

HLE – Linear actuators with timing belt drive
Automation
7 Parker Hannifin GmbH
Electromechanical Division
My
Fy
Fz
Mz
Fx
Mx
The forces and torques the carriage and the timing belt are
capable of transferring are speed-dependent.
The curves shown in the graphs apply to a standard carriage
(S/T).
With the extended carriage (E/F), all the values apart from
Fx (load-bearing capacity of timing belt) can be doubled if
the load is applied equally to both halves of the carriage or
distributed uniformly along its entire length.
The curves show the maximum load-bearing capacity of a
carriage in one direction of force or torque. If several loads
are applied in different directions, the values given by the
curves
must be derated , i.e. the load or speed should be
reduced if necessary.
For precise carriage dimensioning, our software "DimAxes"
is available (Refer to "Other accessories and software", page
34).
3000
2500
2000
1500
1000
500
0
0 1 2 3 4 5
Fx [N] (load-bearing capacity of timing belt)
v [m/s]
HLE80c
HLE100c
HLE150c
250
0
0 1 2 3 4 5
Mx [Nm]
v [m/s]
HLE150c
200
150
100
50
HLE100c
HLE80c
1800
0
0 1 2 3 4 5
Fy [N]
v [m/s]
HLE100c
HLE80c
1600
1400
1200
1000
800
600
400
200
HLE150c
450
0
0 1 2 3 4 5
My [Nm]
v [m/s]
400
350
300
250
200
150
100
50
HLE150c
HLE100c
HLE80c
3500
0
0 1 2 3 4 5
Fz [N]
v [m/s]
3000
2500
2000
1500
1000
500 HLE80c
HLE100c
HLE150c
250
0
0 1 2 3 4 5
Mz [Nm]
v [m/s]
200
150
100
50
HLE150c
HLE100c
HLE80c