Panasonic KX-FL501C - Manual (Page 60)

Error Messages
Reports !
Communication message
COMMUNICATION ERROR
DOCUMENT JAMMED
ERROR-NOT YOUR UNIT
MEMORY FULL
NO DOCUMENT
OTHER FAX NOT RESPOND
PRESSED THE STOP KEY
THE COVER WAS OPENED
OK
40–42
46–52
58, 65
68, 72
FF
43
44
—
54
59
70
—
—
—
—
—
—
● A transmission or reception error occurred. Try
again or check with the other party.
● A line problem occurred. Connect the telephone
line cord to a different jack and try again.
● An overseas transmission error occurred. Try using
the overseas mode of feature #23 (p. 55).
● The document is jammed. Remove the jammed
document (p. 72).
● A transmission or reception error occurred because
of a problem with the other party’s fax machine.
Check with the other party.
● The document was not received due to memory
being full.
● The document was not fed into the unit properly.
Reinsert the document and try again.
● The other party’s fax machine is busy or has run
out of recording paper. Try again.
● The document was not fed properly. Reinsert the
document and try again.
● The other party’s fax machine rings too many
times. Send the fax manually – dial the number,
confirm the fax tone, and press
.
● The other party’s machine is not a facsimile. Check
with the other party.
● The number you dialed is not in service.
● was pressed and fax communication was
cancelled.
● The front cover was opened. Close it and try again.
● Fax communication was successful.
STOP
FAX START
Error
code
Cause & solution
60
If your unit cannot send a fax, check the following:
—the number you dialed is correct,
—the other party’s machine is a facsimile.
If the problem remains, correct it by following the communication message printed on the
sending and journal reports (p. 35).