Porter-Cable N030679 - Manual (Page 19)

19 - ENG
100 Foot
30.5 m
10 A 8.0 5.0 3.1 2.1
15 A 12.0 7.5 4.7 3.2
20 A 16.0 10.0 6.2 4.2
30 A 24.0 15.0 9.3 6.3
150 Foot
45.7 m
10 A 12.0 7.5 4.7 3.2
15 A 18.0 11.3 7.0 4.7
20 A 24.0 15.0 9.3 6.3
30 A 36.0 22.5 14.0 9.5
ACCESSORIES ASSEmBLY
Accessories available for generators
include content shown in Fig 4.
NOTE: Two people are needed for these
installations. Install the wheel kit before
adding gasoline or engine oil to prevent
damage to the engine. If accessories
are being installed after running the
generator, make sure the gas tank is
empty, the fuel shut-off valve is turned
to the OFF position (horizontal to the
ground) and the oil is drained from the
engine
NOTE: After approximately 20 hours of
operation, accessory bolts may loosen.
Tighten them as needed.
hh
(2)
GG
(2)
EE
(2)
QQ)
KK
(2)
mm (4)
LL (4)
DD (2)
FF (2)
NN (4)
pp
OO (4)
II (6)
jj (6)
4
Wheel Kit Assembly
(pCI5000 only)
CAUTION: Risk from Lifting. The
generator may be too heavy to be lifted
by one person. Obtain assistance from
others before lifting.
1. Carefully tilt the generator so it
rests on the engine side.
2. Install the two stands (KK) at the
lower chassis. Use Bolts (MM) and
nuts (LL) for this step.
3. Install the axle (QQ) to the lower
chassis. Use bolts (OO), nuts (NN)
and axle strap (PP) for this step.
4. Slide the wheels (EE) on the axle.