Planet Technology ADSL 2/2+ Router with USB Port ADE-3410v2 - Manual (Page 26)

Choose Add, Edit, or Remove to configure WAN interfaces.
Choose Save/Reboot to apply the changes and reboot the system.
Now we only show you how to add PVC.
3.5.1.1 Configure PPPoE
Click “Add” to add a certain piece of PVC. The following descriptions are given by an
example of adding “PVC 8/35” (PPPOE mode).
Click “Add” following “PVC 8/35”.
In this interface, you can modify VPI/VCI, service categories, and QoS.
VPI (Virtual Path Identifier): The virtual path between two points in an ATM
network, and its valid value is from 0 to 255.
VCI (Virtual Channel Identifier): The virtual channel between two points in an
ATM network, ranging from 32 to 65535 (1 to 31 are reserved for known
protocols).
Service Category: UBR Without PCR/UBR With PCR/CBR/Non Realtime
VBR/Realtime VBR.
Enable Quality Of Service: enable/disable.
In this example, PVC 8/35 is required to modify, so service category and QoS will
remain default values. In actual applications, you can modify them depending on your
practices.
After proper modifications, click “Next” to show the following interface.
In this interface, you can modify Internet Connection Type and Encapsulation Type.
Change the connection type of PVC 8/35 to “PPP over ATM (PPPoE)”.
Select “PPP over ATM (PPPoE)”, and “LLC/SNAP-BRIDGING” (depending on the
uplink equipment, generally “LLC/SNAP-BRIDGING”) as “Encapsulation Mode”.
26