Planet Technology ADSL 2/2+ Router with USB Port ADE-3410v2 - Manual (Page 31)

In this interface, you can modify the Service name and enable/disable the IGMP
Multicast, WAN Service.
IGMP Multicast: IGMP proxy. For example, if you need PPPoA mode support
IPTV, please enable it.
WAN Service: Please enable it, unless you don’t need to active the PVC.
Click “Next”. In this interface, it shows the all configuration. You can see some default
values: NAT enable, Firewall enable.
Click “Save” to save these settings. And you can click “Back” to make any
modifications.
NOTE: You need to reboot to activate this WAN interface and further configure services
over this interface.
3.4.1.3 Configure MER
Click “Add” to add a certain piece of PVC. The following descriptions are given by an
example of adding “PVC 8/35” (MER mode).
Click “Add” following “PVC 8/35”.
In this interface, you can modify VPI/VCI, service categories and QoS.
VPI (Virtual Path Identifier): The virtual path between two points in an ATM
network, and its valid value is from 0 to 255.
VCI (Virtual Channel Identifier): The virtual channel between two points in an
ATM network, ranging from 32 to 65535 (1 to 31 are reserved for known
protocols).
Service Category: UBR Without PCR/UBR With PCR/CBR/Non Realtime
VBR/Realtime VBR.
Enable Quality of Service: enable/disable.
In this example, PVC 8/35 is required to modify, so service category and QoS will
remain default values. In actual applications, you can modify them depending on
your practices.
After proper modifications, click “Next” to show the following interface.
In this interface, you can modify Internet Connection Type and Encapsulation Type.
Change the connection type of PVC 8/35 to “MAC Encapsulation Routing (MER)”.
Select “MAC Encapsulation Routing (MER)”, and “LLC/SNAP-BRIDGING”
(depending on the uplink equipment, generally “LLC/SNAP-BRIDGING”) as
“Encapsulation Mode”.
31