Precor CLIMBER 835 - Manual (Page 20)

18
Assembling and Maintaining the 835 Climber
9. Ask your assistant to hold the upright support while you
attach it to the base frame using four hex head screws
and four washers. Using a ¹₂-inch box wrench or
open-end wrench, tighten the four fasteners in alternating
order until all four are fully secured.
Figure 6: Securing the upright support to the climber base
CAUTION: In the following step, be careful to avoid the sharp
edges on the metal bracket. Do not injure yourself when you
connect the cable.
10. Connect the console power cable to its receptacle on the
base frame.
11. Lower the plastic top cover. Tip the cover to insert the
front tab, then align the rear tab. Apply pressure to lock
the rear tab in place.