Precor CLIMBER 835 - Manual (Page 25)

Chapter
2
Installing the Console
To make installation easier, all Precor Experience Series
consoles use the same mounting hardware and connector
locations whenever possible. The installation sequence for
any of them is as follows:
 Threading the cable assembly
 Connecting cables
 Completing the installation (tightening the mounting
screws and attaching the back cover)
The following sections describe how to perform these tasks.
Threading the Cable Assembly
Earlier in the installation, you threaded the necessary cables
through the frame of the base unit and out the passthrough
opening in the console mount. As you line up the back plate
on the console with the console mount, you must make sure
that the cable assembly passes correctly through the
openings in both components.
Important: Before you begin the following procedure, remove the
rear cover from the control console. Set the cover and its mounting
hardware aside for later use.
To thread the cable assembly:
1.
Make sure that as much of each cable as possible passes
through the opening in the middle of the console mount
on the base unit.
2. Position the console over the console mount.