Precor CLIMBER 835 - Manual (Page 23)

Assembling the Climber
21
3. Secure the lower handrails using four buttonhead screws
and a ⁵₃₂-inch hex key. Fully tighten the fasteners.
4. Using a ¹₂-inch socket wrench, tighten the two nuts
beneath the upper handrail clamp until the handrails
cannot be pulled out of the clamp.
5. Position the two lower handrail boots so that the lip on
each boot faces outward. Slide the boots down onto the
rear crossbar.
6. Position the end caps so that they cover the ends of the
rear crossbar and the lips on the lower handrail boots.
Attach the end caps using two socket head cap screws
and a ⁵₃₂-inch hex key. Tighten the fasteners completely.
Important: The lip of each lower handrail boot should fit
beneath the end cap.
Figure 10: Attaching the end caps
7. Position the water bottle holder as shown and attach it to
the right handrail. Secure the holder using three
Phillips-head screws and a Phillips screwdriver.
Figure 11: Attaching the bottle holder