Polycom QSX 3725-22370-001/B - Manual (Page 13)

3. To dial a device with an extension and password when both are registered to the
same gatekeeper, dial the following sequence:
Dial sequence: #*<Extension>#[password]#
Example: #*2483#1234#
4. To dial a device with a Gatekeeper IP Address, an Extension and a Password, dial
the following sequence:
Dial sequence: #*<IP>**<Extension>#[password]#
Example: #*172*43*16*213**2483#1234#
Note: If you misdial a sequence, you can press #* to reset the dialing sequence and
start over at any time.
Note: If no password is required, you can end the dialing sequence by pressing ##
(e.g.- #*172*43*16*213##).
QSX Info Screen
The Info screen displays status information for the meeting and your QSX system, as
shown below:
This information includes the following:
• Meeting Web Address. The address of the Master Control Unit (MCU)
• Internal IP Address. This is the IP address of the QSX system. It will be the same
as the Meeting Web Address if this QSX is the MCU.
• External IP Address. The External IP Address, if configured, is the address that
allows access to meeting content from outside the LAN. For information about
configuring an external IP address, refer to
page 36 and/or 58 .
• Meeting Password. Six digit password that Web participants will use to log into
QSX meeting. For more information about passwords and password security,
refer to Page 30.
13