Polycom QSX 3725-22370-001/B - Manual (Page 31)

Note: If the QSX is in Idle or Preview mode and there is no H.323 connection (i.e.- only
web viewers are accessing content), you can reset the password and clear all web viewer
connections by holding the Info button down on the QSX 400 for more than 4 seconds.
Note: The password will change on the QSX 300 when the VTX 1000 is taken on/off-
hook. The password will change on the QSX 400 if it is connected to any SoundStation
phone and that phone is taken on/off-hook.
Note: After all the connections are disconnected, a timer on the QSX will be set for 60
minutes. After 60 minutes, the password will automatically change. This ensures that no
unauthorized parties can access a meeting. If you wish to disable this feature, however,
you can set a permanent password by following the steps above.
Location
Location settings allow you configure the QSX based on where it is geographically
located and the language that is spoken there. Accurately setting these configurations
ensures that the proper country codes associated with the local telephony system are
associated with your QSX as well as displaying local VGA and web content
To configure location settings:
1. Log on to the QSX Admin Web as described on Page 23.
2. Go to Admin Settings > General Settings > Location.
3. Configure these settings:
Settings Description
Country
(default: United States) Specifies the country where the system is located.
Changing the country automatically adjusts the
country code associated with your system number.
Language
(default: American English) Sets the language for the local VGA display and web
viewer interface. The QSX Admin Web interface
automatically uses the same language as the
computer operating system.
31