Panasonic DMC-FZ10PP - Manual (Page 127)

Others
127
Message Display
[NO MEMORY CARD]
Insert the card.
[THIS MEMORY CARD IS
PROTECTED]
Cancel the card lock.
[NO VALID IMAGE TO PLAY]
Play back after recording or after
inserting the card with a recorded
picture.
[MEMORY CARD FULL] /
[NOT ENOUGH MEMORY IN THE
CARD]
Insert a new card or delete the
unnecessary data.
[PLEASE CLOSE THE FLASH]
Be sure to close the flash after use.
[MODE DIAL IS NOT IN THE PROPER
POSITION]
This message appears when you turn
the camera on with the mode dial in the
wrong position.
Rotate the mode dial to the proper
position.
[PLEASE SET THE CLOCK]
This message appears when you use
the camera for the first time or you do
not use the camera for a long time.
Set the clock.
[THIS PICTURE IS PROTECTED]
After cancelling the protect setting, you
can delete or overwrite the picture.
[THIS PICTURE CAN’T BE
DELETED] / [SOME PICTURES CAN’T
BE DELETED]
The pictures not based on the DCF
standard cannot be deleted.
[CAN’T BE SET ON THIS PICTURE] /
[CAN’T BE SET ON SOME
PICTURES]
If the pictures are not based on the DCF
standard, the DPOF print cannot be set.
[NO ADDITIONAL DELETE
SELECTIONS CAN BE MADE]
You have exceeded the number of
pictures that can be set at once with
multi-delete setting.
[MEMORY CARD ERROR
FORMAT THIS CARD?]
The format of the card cannot be
recognized by this camera. Format the
card again with this camera.
[SYSTEM ERROR]
This message appears when the
camera does not operate properly. Turn
the camera off and on. If the message
persists, contact the dealer or your
nearest servicenter.
[MEMORY CARD ERROR]
Failed access to the card.
Insert the card again.
[READ ERROR]
Data reading error.
Play it back again.
[WRITE ERROR]
Data writing error.
Turn the camera off and remove the
card. Then insert the card and turn the
camera on again. Be sure that the
camera is turned off before removing or
inserting the card to avoid damage.
FZ10-PP.book 127 ページ ２００３年１１月１８日 火曜日 午後１時７分