Panasonic DMC-FZ10PP - Manual (Page 80)

Recording pictures (advanced)
80
Using the Optical Image Stabilizer
Preparation
• Set the mode dial except for [
]. (P30)
1 Select [STABILIZER] and set it.
• [OFF]:
When image stabilization is not
desired or when using a tripod.
• [MODE1]:
The stabilizer operates
continuously and can assist during
photocomposition.
• [MODE2]:
The stabilizer function is in standby
and activates at the moment the
shutter captures the image. This
mode offers a greater degree of
stabilization.
• Close the menu by pressing the
[MENU] button after finishing the
setting.
¬Suggestions/Tips ¬
• In [MODE2], the optical image
stabilizer icon turns yellow soon after
you turn the camera on to keep the
stabilizer function activated.
• While the optical image stabilizer icon
is displayed in yellow and if the
camera receives a strong shock, the
icon may be displayed in yellow for
longer time than usual.
• While the optical image stabilizer icon
is displayed in yellow, the stabilizer
function may not work sufficiently.
• While the optical image stabilizer icon
is displayed in yellow, the pictures on
screen also be stabilized. (as same as
in [MODE1])
• The stabilizer function may not work
sufficiently in the following cases.
– When too much jitter occurs
– In digital zoom range
– When taking pictures while following
subjects in motion.
– When the shutter speed is extremely
slow due to nightscape or other
reasons.
• Refer to P33 for information on jitter.
MENU
SET
WB
REVIEW
SET
WB
REVIEW
REC 3 / 4 SETUP
PICT.ADJ.
STABILIZER
FLIP ANIM.
COL.EFFECT
OFF MODE2 MODE1
EXIT SET SELECT MENU
OFF
OFF
1
2
FZ10-PP.book 80 ページ ２００３年１１月１８日 火曜日 午後１時７分