Panasonic TC 22LR30 - Manual (Page 15)

15
Getting Started
Connections
Notes on connections
• Turn off the power supply for all components before making any connections.
• If the cables necessary for connecting a component to the system are not included with the component or available as an option, you may need to
fashion a cable to suit the component concerned.
• Read the instruction manual for each system component carefully before connecting it.
Connect the cable from Antenna to the VHF/UHF terminal on the
unit.
Cable Connection
Overtightening “Nut type” RF coaxial cables may damage jacks. Finger tighten only.
Connecting the RF in Terminal
Note to CABLE system installer:
This re mind er is pro vid ed to call the CABLE (Cable TV) System
Installer’s at ten tion to Article 820-40 of the NEC that pro vides
guide lines for proper grounding and, in par tic u lar, specifies that
the cable ground shall be con nect ed to the ground ing system of
the build ing, as close to the point of cable entry as practical.
Cable Box
In from CABLE
VHF
Antenna UHF
Antenna
CAUTION
Or
Mixer
Antenna Connection
Connect the cable supplied by your local cable company to VHF/
UHF terminal on the unit.
Note:
• When the RF coaxial cable is connected to the projection display VHF/
UHF terminal via a cable box or VCR, set the TV channel to CH3 or CH4.
This does not apply when signal is input from VIDEO INPUT.
Use this configuration when connecting the LCD TV Antenna and
Cable TV system using VCR.
Or
Connect the cable from the Output
terminal on the back of the Cable
Box or antenna/cable system to the
Antenna input terminal on the back
of the VCR.
VCR
Incoming Cable from
Antenna or Cable TV System
↑ TO VCR
In from cable
TERMINAL ON THE
BACK OF THE CABLE
BOX
CABLE BOX
↑ TO VCR
Connecting the Antenna / Cable to the RF IN
Terminal (VCR)
Cable / Antenna Connection
Incoming 75Ω Cable from
Home Antenna / Cable
Company
F-Type Antenna
Connector
Antenna
Terminal on the
Back of the TV