Panasonic AG-TL950 - Manual (Page 15)

15
CCD
CCD
CCD
CCD
CCD
CCD
1 2 3 4 5 6
1 2 3 4 5 6
AC~IN R S - 2 3 2 C
CAM SW
OUT
ALARM
IN
COM
COM ALARM
REC OUT ALARM
RESET TAPE END OUT
WARNING
OUT
CLOCK
RESET IN
SERIES
REC IN
SERIES
REC OUT CLOCK RESET OUT SPARE MIC
IN
OUT
AUDIO VIDEO
S-VIDEO
3-2 System Using Sequential Switcher
Video camera
Alarm sensor input
Alarm sensor
Microphone
Alarm signal output
Camera switching
signal input
Sequential switcher
Amplifier
AC 120 V
50 Hz/60 Hz
3 CONNECTIONS
Video output
Monitor TV
Mains cable
BNC
BNC Phono
Phono
4pin
1 Connect video cameras and alarm sensor to a sequential switcher (frame switcher).
2 Connect the sequential switcher’s (frame switcher) alarm signal output, camera switching signal input and video output to
the AG-TL950P.
3 Connect the monitor’s video/audio input connectors to the AG-TL950P’s video/audio output connectors.
4 When the connection is complete, connect the power plug to an AC 120 V, 50 Hz/60 Hz socket.
5 Synchro should be applied to all connected video cameras.
6 If you are connecting the camera switching signal input from a sequential switcher (frame switcher) to the AG-TL950P, be
sure to set the <CAMERA SW> menu switch.
CAM SW
OUT ALARM IN