Panasonic AG-TL950 - Manual (Page 38)

38
AL
TIME MODE
REC
EJECT
REC REVIEW REC
PAUSE/
STILL MENU TIME MODE
SET
ON SCREEN
SHIFT /REW PLAY FF/ REV PLAY TRACKING V. LOCK TIMER SEARCH COUNTER LOCK CNT RESET
RESET / CANCEL
STOP
REV ADV FWD ADV
POWER
HDR
POWER
AG-
6-4 Alarm Recording
Alarm recording functions during timelapse recording. When an alarm signal is input to the rear panel’s ALARM IN terminal, an
index code is recorded on the tape and the VCR automatically switches to the 2H/6H/L12H/L18H/L24H/24H/48H/NORMAL
mode for realtime recording of the alarm situation. Normal timelapse recording is restored after the preset alarm recording
duration has passed.
* Alarm recording will not start from the Pause mode.
* An index code (VISS) is recorded at the start point of the alarm recording as an alarm cue signal.
* During alarm recording, a +12 V signal is output from the rear panel’s ALARM REC OUT terminal.
* If a new alarm signal is input during alarm recording, alarm recording restarts from that point.
6 RECORDING
On-screen
"ALARM"
indication
Extinguished
Extinguished
Shown Shown Extinguished Extinguished
Display "AL"
indication
Lit Lit Blinking Blinking
Record mode
Timelapse
mode Timelapse
mode Timelapse
mode
Timelapse
recording Timelapse
recording Timelapse
recording Alarm
recording Alarm
recording
Alarm signal input Alarm signal input
2H/6H/L12H/
L18H/L24H/24H/
48H/NORMAL 2H/6H/L12H/
L18H/L24H/24H/
48H/NORMAL
5 Menu switches are provided for alarm recording mode,
alarm recording duration, buzzer ON/OFF in alarm
recording, and Forced Stop mode ON/OFF at tape end.
5 During alarm recording, the [AL] indication is lit on the
VCR and the [ALARM] indication is lit on the monitor
display. After alarm recording is complete, the “AL”
indication blinks on the display to show that an alarm
signal has been input.
* If the alarm recording function is activated a hundred
times a day or more, a malfunction may occur because
the guaranteed range is exceeded.
If you want to use this unit more than a hundred times
a day, set the recording speed mode to 2H/6H and
perform regular maintenance, replacing parts as
necessary.
“AL” indication