Planet Technology Pre-N Wireless Router WNRT-610 - Manual (Page 11)

Chapter 2 Hardware Installation
Before you proceed with the installation, it is necessary that you have enough information about the
WNRT-610.
2.1 Hardware Connection
1. Locate an optimum location for the WNRT-610. The best place for your WNRT-610 is usually at
the center of your wireless network, with line of sight to all of your mobile stations.
2. Connect the power adapter to the receptor at the rear panel of the WNRT-610, and plug the other
end of the power adapter to a wall outlet or power strip. The Power LED will light up to indicate
proper operation.
3. Power off the ADSL / Cable modem first. Connect ADSL/Cable Modem to the WAN port on
WNRT-610. Use the cable supplied with your modem. If no cable was supplied with your modem,
please use a RJ-45 Ethernet cable. After the Ethernet cable is securely connected, power on the
ADSL / Cable modem. The WAN LED will light up to indicate proper connection.
4. Use an Ethernet cable to connect one of the LAN ports on the WNRT-610 and the computer you
are using to configure the router. The corresponding LAN LED will light up to indicate proper
connection. The LAN ports on the WNRT-610 are Auto-MDI/MDIX; thus, you can use a straight or
crossover Ethernet cable freely.
5. Adjust the antennas of WNRT-610. Try to adjust them to a position that can best cover your
wireless network. The antenna’s position will enhance the receiving sensitivity.
Note: ONLY use the power adapter supplied with the WNRT-610. Otherwise, the product may be
damaged.
Note: If you want to reset WNRT-610 to default settings, press and hold the Reset button over 5
seconds. And then wait for 10 seconds for WNRT-610 restart.
- 5 -