Panasonic AJ-D230HP - Manual (Page 23)

Set-up (Default Settings)
The VTR’s major settings are performed by making selections using a menu system. The set-up
menus appear on the TV monitor when it is connected to the MONITOR OUT connector.
Changing a setting
1
Set the VTR to the menu mode.
(Set the LOCAL/MENU/REMOTE switch to the MENU position.)
2
Select the item to be set using the UP (FF) and DOWN (STOP) buttons. The cursor
on the menu screen moves and selects the item.
The cursor ( ) is moved to the previous set-up menu item number using the DOWN
button and the next set-up menu item number using the UP button.
3
Press the DATA+ (PAUSE/STILL) button or DATA– (PLAY) button to change the
setting.
4
Upon completion of the setting, press the SET (REC) button.
The change is now stored in the memory.
To return from the new setting to the original setting, set the LOCAL/MENU/REMOTE
switch to the LOCAL or REMOTE position instead of pressing the SET (REC) button.
5
Set the LOCAL/MENU/REMOTE switch to the LOCAL or REMOTE position.
<Note>
To return the setup selections to the factory (default) settings, press the RESET button while the
SETUP. menu is shown. The following message is then displayed.
SETUP-MENU INIT. SET
OK? (PUSH REC KEY)
The default settings will be restored when the REC button is pressed.
1
2 3 4
23