Panasonic DMC-LS2 - Manual (Page 81)

Connecting to other equipment
81
VQT0V10
Playing Back Pictures
on a TV Screen
∫ Playing back pictures using the video
cable (supplied)
• Turn the camera and the TV off.
1 Connect the video cable A
(supplied) to the [V.OUT] socket
on the camera.
• Connect the video cable with the [ ]
mark facing the [ 1] mark on the
[V.OUT] socket.
• Hold the video cable at B and insert
straight in or take straight out.
2 Connect the video cable to the
video input socket on the TV.
• 1 Yellow: to the video input socket
3 Turn the TV on and select external
input.
4 Turn the camera on.
• Do not use any other video cables except
the supplied one.
• The top and bottom or left and right of the
picture may be cut off slightly when it is
displayed due to the characteristics of the
TV.
• Depending on the screen mode setting of
the TV when you connect the camera to a
wide-screen TV or a high-definition TV,
the picture may be stretched horizontally
or vertically and the top and bottom and or
left and right of the picture may be cut off
when it is displayed. In this case, change
the screen mode setting.
• Read the operating instructions for the TV.
• When you play back a picture vertically, it
may be blurry.
• You can view pictures on TVs in other
countries (regions) which use the NTSC
or PAL system when you set
[VIDEO OUT] in the [SETUP] menu. Even
if you set [VIDEO OUT] to [PAL], the
output signal will still be NTSC in the
recording mode.
∫ Playing back pictures on a TV with an
SD Memory Card slot
Still pictures recorded on an SD Memory
Card can be played back on a TV with an
SD Memory Card slot.
• Depending on the TV model, pictures may
not be displayed on the full screen.
• Motion pictures cannot be played back. To
play back motion pictures, connect the
camera to the TV with the video cable
(supplied).
• You may not be able to play back
MultiMediaCards.
DIGITAL
V.OUT
DC IN
3V
VQT0V10ENG.book 81 ページ ２００５年１２月２７日 火曜日 午後８時３４分